A.H. Systems AK-285R 운영 매뉴얼 - 페이지 10

{카테고리_이름} A.H. Systems AK-285R에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A.H. Systems AK-285R 15 페이지. Shielding effectiveness antenna kit

A.H. Systems AK-285R Shielding Effectiveness Antenna Kit

TRIPOD AND MOUNTING ADPTERS

ATU-510 Tripod

AEH-510 Azimuth and Elevation Head

The azimuth and elevation head (AEH-510) mounts to the tripod (ATU-510) top

and allows the antennas to be rotated 360 degrees, titled up and down between

horizontal and vertical polarization. The tripod and azimuth and elevation head

come in their own carrying case. Each tripod leg is independently adjustable in

angle and length to facilitate antenna height setting. The tripod legs have a rubber

tip on one end for indoor or hard surface use, and a metal spike on the other end

for outdoor soft surface (such as dirt) use.

TRANSIT STORAGE CASES

TCC-510 Tripod Carrying Case

TSC-542 Transit Storage Case

The antenna carrying case (TSC-542) prevents damage and loss of antennas

when storing or transporting the antenna kit. The case is constructed of lightweight

and durable polyethylene. Two case keys are provided with the case.

OPTIONAL EQUIPMENT

The AK-285R case comes with three additional cutouts for optional

preamplifiers. In order to improve overall system sensitivity, the following

equipment will be required:

PAM-0118 Preamplifier 20 MHz – 18 GHz

The preamplifier will increase the system sensitivity 33 dB and is recommend for

the SAS-510-2, SAS-544F and SAS-571. An optional short length cable (SAC-

18G-0.5), is required to connect the preamplifier to any 50-ohm receiver or

spectrum analyzer.

NOTE: Care must be exercised to insure that the maximum input signal or ESD

does not exceed +10 dBm causing damaged to the preamplifier.

SAC-18G-0.5 Low-Loss Cable up to 18 GHz

The Low-Loss, High Frequency cable is recommend for connecting the optional

preamplifier to any 50-ohm receiver or spectrum analyzer. Our Low-Loss High-

Frequency flexible cables are the preferred choice over standard cable types. With

improved power handling, low VSWR, and high frequency capabilities, the Low-

Loss cables can be made to your specified length and delivered in two days. The

1/2 meter SAC-18G-0.5 has a typical attenuation of 1.0 dB at 18GHz.

REV A

•

PAM-0118 with an SAC-18G-0.5

•

PAM-1840 with an SAC-40G-0.5