Aqua Creek Products EZ Series 매뉴얼 - 페이지 7

{카테고리_이름} Aqua Creek Products EZ Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products EZ Series 11 페이지. Pool lift and hard seat option
Aqua Creek Products EZ Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

NOTE: For safety, check for worn parts and loose bolt connections prior to each use. All operators

should be familiar with all lift components and their intended uses. Operators should also be

comfortable with all lifting procedures before attempting to lift a person with the lift.

The EZ 2 Pool Lift requires the use of an operator to assist the lift occupant with the transfer into the pool.

There are two methods of loading the lift occupant into the harness. The method of loading will depend

on the physical ability of the lift occupant. If the user is physically able, he/she can simply place themself

into the harness without need for assistance. If the user has very limited use of his/her upper body, it will

be necessary to follow the procedure below.

1. With the lift in the raised position and the boom arm located over the deck, roll the user under the lift

and engage the brakes on the wheelchair.

2. With the user facing the assistant, gently slide the mesh seat sling under the seated user while still in

the wheelchair.

3. Attach the chain to the mesh sling and the overhead hanger bar. Avoid excess slack in the chain.

4. Ensure all chain connections are secure and the mesh seat sling is even on each side of user.

5. Raise the user by pumping the hydraulic ram handle until the desired height is achieved.

6. Rotate the lift so that the user is above the pool. Never push on the actuator! Use the turn bar or

place one hand on the boom arm and one hand on the mast.

7. Lower the user into the water by pressing the handle towards the ram until it depresses the release

pin. The hydraulic ram automatically controls the rate of descent for safety and control. Lower until

the user is submerged sufficiently in the water to allow an easy transfer to the pool.

8. This procedure is repeated to remove a user from the water.

9. When the lift is not in use, remove the sling, hanger bar and mast from the anchor socket and replace

the protective cap.

Thank you for purchasing the Aqua Creek EZ 2 Pool Lift. Enjoy the pool

and this product for many years with proper use and maintenance.

Operating Instructions

See page 10 of this manual for proper care instructions.

Revised 11/1/19