Aqua Creek Products F-004PLB-AT1 매뉴얼 - 페이지 8

{카테고리_이름} Aqua Creek Products F-004PLB-AT1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-004PLB-AT1 14 페이지. Pool lift

페이지 인쇄

1. Attach seat belt to the seat.

2. Install the Ranger-AT pool lift onto the four (4) anchors

using the supplied 1/2 inch x 1 1/2 inches stainless steel hex-

head bolts and 1/2 inch stainless steel flat washers. Make sure

all bolts are tight before using the lift.

5. Remove the fully charged battery

from the charger, grease the terminals,

and install it on top of the control

box. The battery will line up with the

control box, and will 'click' when it

properly locks in place. The lift will

only operate when the battery is

correctly mounted.

WHEN NOT IN USE, STORE THE

BATTERY ON THE CHARGER!

Pro Pool-AT Assembly Instructions

SEE FIGURE D

3. Apply dielectric

grease to the plug

terminals. Plug the

handset cable to

extension cord/bracket located behind chair. Press the cord

end firmly into the socket until you are sure it is completely

in the socket. Failure to fully push the remote cord into the

socket may result in faulty or interrupted operation.

4. Before installing the battery, place it on the charging unit

and let it charge for 24 hours. Make sure the orange "charge"

light illuminates when the battery is being charged.

ATTACH

FULLY-CHARGED

BATTERY

CONTROL BOX

1/2" X 1-1/2"

HEX BOLT (4)

1/2" FLAT

WASHER (4)

ANCHORS (4)

INSTALLED FLUSH

W/DECK SURFACE

LOOP ON TOP

FOR EASY ACCESS

THREAD THROUGH

SLOTS AND PINCH

FIGURE D

TOGETHER TO HOLD

HANDSET

PLUGS INTO

CONTROL BOX

Revised 12/2/15

POOL

WALL