Aqua Creek Products F-004XRDD-NA 매뉴얼 - 페이지 7

{카테고리_이름} Aqua Creek Products F-004XRDD-NA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-004XRDD-NA 18 페이지. Pool lift without anchor

페이지 인쇄

Anchor Installation: Saw-cut Retro-fit

Required Tools:

• Concrete saw with diamond blade

• Tape measure

• 4' long straight edge or chalk line

• Sledge hammer

• Cold chisel

• Torpedo level

• String line

• Concrete and concrete tools

• #4 Rebar

FIGURE 5

ANCHOR BOLT (3)

Cu BONDING LUG

ANCHOR JIG-PLATE

#10-24 NYLOCK NUT

1/4" FLAT WASHER

1/4" X 3/4" PAN-HEAD

SIDE VIEW (ASSEMBLED)

45"

BONDING

45"

LUG

LABEL

REBAR

FLUSH W/ DECK

2500 PSI MIN.

DRILL & EPOXY INTO EXISTING

SLAB (4" MIN EMBED)

*SETBACK DIMENSIONS ARE FOR FLAT DECK APPLICATIONS.

FOR SLOPED DECKS OR OTHER FEATURES, CONTACT AQUA

CREEK BEFORE INSTALLATION.

1. Locate the anchor plate, three (3) anchor inserts with nuts and

Bonding Lug

mounting hardware). (If sold separately from lift, part number

F-910SAJP).

2. Mark out a section of the pool deck to be removed using a chalk

line or straight edge and a marker. Plan on removing at least a

3'-9" x 3'-9" x 6" section.

3. Using the saw with the diamond blade, make cuts along the

lines previously marked.

1" X 4"

4. Using the sledge hammer, break up the concrete within the area

cut and remove the pieces.

#10-24 X 3/4"

CAP-SCREW

5. After the portion of the deck has been removed, verify the new

1" HEX NUT (6)

deck will be able to be at least 6 inches deep.

6. Remove ONE of the nuts from each of the anchor inserts and

place the anchor inserts through the larger holes in the anchor

plate. Thread the nut back on the other side of the anchor insert

so the anchor plate is sandwiched between the nuts. (See FIG 5).

7. Install rebar in the open area of the deck. Tie the rebar into the

existing deck if possible.

8. Set the anchor system in place making sure the center line of the

anchor inserts are no more than 38 inches away from the pool's

edge.

9. Use the string line or a straight edge to make sure the top of

12"

TYP

38"

each anchor bolt is level and flush with the FINISHED deck

MAX

surface. Each anchor bolt can be adjusted individually by

8-AWG SOLID-

turning the nuts with a large wrench.

COPPER WIRE

(ATTACH TO

BONDING-GRID)

10. Bond the anchor system using the bonding lug on the anchor

jig-plate. The anchor should be bonded to the pool's bonding-

grid according to local code requirements. (Reference NEC

Article 680.26).

11. Pour concrete and finish the pool deck surface.

POOL WALL OR

FURTHEST

OBSTRUCTION

12. Once the concrete has cured, install the lift by aligning the holes

in the lifts base with the anchors installed in the deck. Secure

#4 REBAR E-W (4 PCS)

the lift to the deck using the stainless steel hardware provided.

Be sure to use anti-seize on all hardware.

FIGURE 6

Revised 12/3/15