Avlite AV-OL-60 설치 및 서비스 매뉴얼 - 페이지 8
{카테고리_이름} Avlite AV-OL-60에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avlite AV-OL-60 20 페이지. Solar obstruction light
Avlite AV-OL-60에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지)
페이지 인쇄Intensity/power settings on Avlite lanterns operate via DIP switches, located near the rotary switches
on the flasher unit. The intensity/power settings may be used to reduce the power consumption and
intensity of the lantern. Setting the lantern to 25% intensity will reduce the power consumption to 25%
of the normal 100% setting and the range by 25%. This setting may be used to adjust the current draw
of the light to local sunlight conditions.
The following diagrams indicate intensity/power settings:-
ON
ON
1
2
1
100%
50%
Power Consumption Calculator
Night Hours
(use 13.7 if
unknown)
X
Total power
used per night
(mAh)
/
If the number of Full Sunlight hours is less than 2.5-3.0 hours, please consider reducing the intensity
(Power) or reducing the Duty Cycle.
Selecting a Flash Code - Rotary Switches A & B
All lights have 2 rotary switches marked A and B on the flasher unit. Turning the small arrows to the
appropriate number or letter will set the code (see 'Flash Codes' section, of this manual). The unit may
take up to one minute to activate a new flash code. A comprehensive list of available flash codes is
listed on pages in the 'Flash Codes' section of this manual.
Example:
SWITCH FLASH CODE
A
B
A
0
FL 3 S
Latest products and information available at www.avlite.com
Selecting an Intensity/Power Setting
ON
2
1
2
50%
Power
mA/hour
X
Solar Panel
Charge (mA)
176
=
ON
OFF
0.3
2.7
ON
1
2
25%
Duty Cycle
(e.g. 20% = 0.2)
Number of full sunlight hours
required to break even
(the amount of time it will take for the solar to
replace what the light took out overnight)
8
AV-OL-60
Solar Obstruction Light
Intensity
Power
Setting
mA / hour
100%
84-86
50%
42-44
25%
21.-23
Total power
used per night
(mA)
=
B
A