Aqua Creek Products F-005SLU 지침 매뉴얼 - 페이지 6
{카테고리_이름} Aqua Creek Products F-005SLU에 대한 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-005SLU 12 페이지.
Aqua Creek Products F-005SLU에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지)
Spa Lift Ultra Installation and Assembly
5. Connect the control arm to the mast using the 1/2 inch shoulder bolt and 3/8 inch nylock and fl at washer, as
shown in FIGURE 6. Careful not to scratch the control arm on the lifting arm while attaching.
6. Connect the chair arm assembly to the lifting and control arms using the 1/2 inch shoulder bolts and 3/8 inch
nylocks and fl at washers. This may require two people. See FIGURE 7.
LIFTING ARM
3/8" NYLOCK
3/8" FLAT WASHER
ACTUATOR
FIGURE 6
7. Attach the safety belt to the chair, as shown in FIGURE 8.
8. The Spa Lift Ultra is now assembled and ready for use! Be sure the battery is fully charged. FIGURE 9 shows
completed assembly mounted on a spa deck. NOTE: With the lift fully assembled, run the lift fully out and back
in 3-5 times, without weight, for the lifts "break in" cycle period.
LOOP ON TOP
FOR EASY ACCESS
FIGURE 8
Copyright © 2020 Aqua Creek Products All Rights Reserved
CONTROL ARM
1/2" X 2 3/4"
SHOULDER BOLT
MAST ASSEMBLY
THREAD THROUGH
SLOTS AND PINCH
TOGETHER TO HOLD
3/8" FLAT WASHER (2)
3/8" NYLOCK (2)
CHAIR ARM
ASSEMBLY
FIGURE 7
FIGURE 9
1/2" X 3" SHOULDER
BOLT (2)
6
Revised 6/25/20