Aqua Creek Products F-005SLU-05 지침 매뉴얼 - 페이지 6

{카테고리_이름} Aqua Creek Products F-005SLU-05에 대한 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-005SLU-05 12 페이지.

Spa Lift Ultra Installation and Assembly

5. Connect the control arm to the mast using the 1/2 inch shoulder bolt and 3/8 inch nylock and fl at washer, as

shown in FIGURE 6. Careful not to scratch the control arm on the lifting arm while attaching.

6. Connect the chair arm assembly to the lifting and control arms using the 1/2 inch shoulder bolts and 3/8 inch

nylocks and fl at washers. This may require two people. See FIGURE 7.

LIFTING ARM

3/8" NYLOCK

3/8" FLAT WASHER

ACTUATOR

FIGURE 6

7. Attach the safety belt to the chair, as shown in FIGURE 8.

8. The Spa Lift Ultra is now assembled and ready for use! Be sure the battery is fully charged. FIGURE 9 shows

completed assembly mounted on a spa deck. NOTE: With the lift fully assembled, run the lift fully out and back

in 3-5 times, without weight, for the lifts "break in" cycle period.

LOOP ON TOP

FOR EASY ACCESS

FIGURE 8

CONTROL ARM

1/2" X 2 3/4"

SHOULDER BOLT

MAST ASSEMBLY

THREAD THROUGH

SLOTS AND PINCH

TOGETHER TO HOLD

3/8" FLAT WASHER (2)

3/8" NYLOCK (2)

CHAIR ARM

ASSEMBLY

FIGURE 7

FIGURE 9

1/2" X 3" SHOULDER

BOLT (2)

Revised 6/25/20