Aqua Creek Products F-12PPL-HD-AT2-05 매뉴얼 - 페이지 4

{카테고리_이름} Aqua Creek Products F-12PPL-HD-AT2-05에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-12PPL-HD-AT2-05 14 페이지. Portable lift

TOOLS REQUIRED:

• 7/16" wrench or socket

1. To begin, place parts near the desired

poolside location.

2. Stack supplied weight plates on portable

platform. Check every three (3) or four (4) are

aligned properly by temporarily sliding cover

over plates. Continue this until all ten (10)

weight plates are in place.

3. Attach the cover assembly over the weight

stack using a 7/16 inch wrench or socket and

the supplied 1/4 inch nylock nuts and 1/4 inch

fender washers. See fi gure to the right.

4. Attach the seat belt through the loops in the

seat base and pinch the hook & loop material

together. See diagram in bottom left.

5. Place the battery on the charger and bring to

a full charge. NOTE: To extend battery life,

always store battery on the charger when

the lift is not in service.

6. Apply supplied dielectric grease on the metal

tabs of the battery and the control box on the lift.

7. Mount the battery onto the control box and snap the battery into place. Listen for a 'click'

LOOP ON TOP

FOR EASY ACCESS

THREAD THROUGH

SLOTS AND PINCH

TOGETHER TO HOLD

Patriot-AT2 Assembly Instructions

when the battery is installed properly. There should be no gap

between the battery and control box. See diagram below.

COVER

WEIGHT PLATES (10)

1/4" FENDER WASHER (12)

1/4" NYLOCK NUTS (12)

BATTERY

CONTROL BOX

Revised 6/18/19