Aqua Creek Products F-702RLNA-SPA-02 매뉴얼 - 페이지 11

{카테고리_이름} Aqua Creek Products F-702RLNA-SPA-02에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-702RLNA-SPA-02 18 페이지. Revolution spa lift

Pull-out Legrest Installation Instructions

3. Orient the pull-out legrest as shown in FIGURE 10 and slide the PLASTIC

GUIDE/SPACER into the chair support tube. Tap the PLASTIC GUIDE/

SPACER with a hammer or mallet until fl ush with the end of the support

tube. The threaded hole in the bottom of the PLASTIC GUIDE/SPACER should line-up with the hole drilled

in the chair support tube. Install the lock washer and 1/4 -20 x 1/2 inch cap screw from underneath and

tighten until snug.

PLASTIC GUIDE/SPACER

The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put the pad

up and down to make sure everything works smoothly.

LEGREST STOWED

1" SQ. TUBE

CHAIR SUPPORT TUBE

PULL-OUT LEGREST

PLASTIC GUIDE/SPACER

FLUSH WITH 2" SQ. TUBE

FIGURE 10

PULL LEGREST OUT

SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION

1/4" LOCK WASHER, SS

1/4-20 X 1/2" CAP SCREW, SS

FLIP LEGREST UP AND PIN

SLOT

You Will Need:

•

Flat head Screwdriver

•

Hammer / Mallet

•

5/32" Allen Wrench

Revised 11/30/18