Aqua Creek Products Mighty 400 매뉴얼 - 페이지 6

{카테고리_이름} Aqua Creek Products Mighty 400에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products Mighty 400 15 페이지. Pool lift

Anchor Installation: Core-drill Retro-fi t

Place the anchor in the hole and 'dry-fi t' it fi rst to make sure the anchor will be fl ush and

plumb with the fi nished deck surface when installed. Adjust the hole as needed.

NOTE: Pool decks with pavers or thick tiles may require other anchor options. Contact Aqua Creek Products.

Inject epoxy adhesive into each hole starting at the bottom until the hole is 1/3 to 1/2 full.

NOTE: We recommend using masking tape around the top of the anchors so that no epoxy gets inside the anchors.

1/2" X 1 1/2"

HEX BOLT

1/2" FLAT

WASHER

1" X 4"

FIXING ANCHOR

Install the anchor into the epoxy fi lled hole by pushing down and twisting back and

forth to evenly distribute the epoxy around the anchor. Push down until it is fl ush with the

fi nished deck surface. Clean oﬀ any excess epoxy. Adjust the anchor as needed to make

sure it is fl ush and plumb with the deck surface. This should be done during the adhesives'

specifi ed 'gel time' (see epoxy manufacturers' instructions).

Let the epoxy cure for at least 24 hours before installing the lift (or where applicable

according to the epoxy manufacturers' instructions).

FIGURE A

(CONTINUED)

MIGHTY LIFT

MAIN ASSEMBLY

1.9" POST

1.9" X 6" ANCHOR

(AQUA CREEK OR

EQUIVALENT)

ANCHOR MUST BE BONDED

ACCORDING TO LOCAL

REQUIREMENTS

Revised 6/24/20