Aqua Creek Products REVOLUTION F-702RLNA-SPA 매뉴얼 - 페이지 9
{카테고리_이름} Aqua Creek Products REVOLUTION F-702RLNA-SPA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products REVOLUTION F-702RLNA-SPA 16 페이지. Revolution spa lift
Aqua Creek Products REVOLUTION F-702RLNA-SPA에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)
페이지 인쇄
Pull-out Legrest Installation Instructions
The PULL-OUT LEGREST ASSEMBLY is designed to fit under the standard Aqua Creek chair, and is installed
inside the 2" square tubing that supports the chair from underneath. Installation is the same for every lift,
Ranger lift is shown in picture below. To install the pull-out leg-rest;
1. With a flat-blade screwdriver, pry off the 2" square plug from the end of the 2" square tube of the seat arm.
SEE FIGURE 8.
2. Drill a 9/32" hole at the location indicated in FIGURE 9 through the bottom of the chair support tube. Drill
only through the bottom of the tube. Remove the burrs from the hole before installing the legrest assembly.
Copyright © 2017 Aqua Creek Products All Rights Reserved
2" SQUARE
PLUG
DRILL
9/32" HOLE
(BOTTOM OF CHAIR SUPPORT TUBE)
(SEE DRAWING TO THE RIGHT)
SEAT
SEAT ARM
FIGURE 8
DRILL
9/32"
(THIS SIDE)
CHAIR SUPPORT TUBE
(BOTTOM VIEW)
FIGURE 9
3/4"
1"
9
Revised 12/13/17