ab command iX2 사용 설명서 - 페이지 9

{카테고리_이름} ab command iX2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ab command iX2 17 페이지. Electronic fitness system
ab command iX2에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (6 페이지)

페이지 인쇄

CONTROLS

Front channel up

Front channel down

Rear channel up

Rear channel down

On / Off button

Mode button

toggle through:

Mode

Intensity

Timer

Target Area

KEY LOCK TOGGLE ON/OFF:

Press and hold the Mode M button for 3 seconds.

USAGE GUIDE

FIRST OPERATION

1. Open the battery compartment by sliding the

door gently downwards (please see diagram).

2. Insert 2 x AAA batteries by following the polarity

indications in the compartment.

3. Attach the control unit to the belt by simply plugging the cable

into the control unit.

4. Attach the Conductive Pads to the belt by

simply clipping them on using the press

studs.

5. Make sure the unit is switched off, i.e., the LCD display is OFF.

If you accidentally switch the unit on, please press and hold the

ON/OFF button for 3 seconds to switch it off again.

TIP! Adjust the belt to a tight and comfortable fit WITHOUT gel first.

Then apply the gel and wear the belt for your workout.

6. Place the new AbCommand™ iX2™ belt around your stomach and

fasten the belt to a comfortable, but tight fit pursuant to the

directions in the First Use Guide.

7. Take the belt off again, turn it on its

face and place a generous dab of

AbCommand™ iX2™ Conductive

Gel onto each of the four Conductive

Pads.