AVM OVATION SA 6.3 사용 설명서 - 페이지 8

{카테고리_이름} AVM OVATION SA 6.3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVM OVATION SA 6.3 12 페이지.

2.2 Display button

If the display disturbs you while listening to music, you can switch it off by pressing the display button

(5).

2.3 Advanced settings menu

The MA / SA 6.3 offers a wealth of custom-specific settings in its advanced settings menu which may

be accessed during operating or standby mode. To enter the menu, just tap on the MENU button (3).

The currently selected menu point is indicated in the upper area of the display in capital letters – the

respective option is indicated below in lowercase characters. To skip through the available menu

points, use the menu buttons named < ITEM >. To change the setting or option of a selected menu

point, use the menu buttons named < VALUE >. To store and exit the menu again, just press the menu

button EXIT.

2.3.1 Set display brightness

Selects the display brightness from 100%, 75%, 50%, to 25%.

NOTE: The display brightness can also be remotely controlled, if an AVM model of the PA or SD series

is used as a pre-amplifier and remote is set as operating mode (see section 2.3.3)

2.3.2 Set display mode

bargraph & value: While operating, a bar informs about the actual output level. The peak output power

is displayed numerically.

value: Only the peak output power is indicated numerically.

CLIP indicates the demanded output power exceeded the maximum. In this case, we recommend to

reduce the volume in order to not damage the tweeters of your tweeters.

2.3.3 Set operating mode

permanent: When switched on using the mains switch (13), the unit is permanently ready to operate

until it is switched off with the mains switch.

automatic: The amplifier switches on automatically as soon as a connected pre-amplifier delivers an

audio signal to one of the analog inputs (7, 8). Standby mode is activated as soon as the pre-amplifier

has not delivered a signal for more than 10 minutes.

trigger: Switching to operating mode and to standby is controlled via the trigger input (10). For details,

see section 0.

remote: If you happen to use an AVM model of the PA or SD series as a pre-amplifier, your MA / SA

6.3 can be automatically switched on and off via inaudible digital signals sent over a connected audio

cable – without the need for an additional trigger cable. In addition, the display brightness can also be

remotely controlled – according to the selected setting on the pre-amplifier (see section 2.3.1).

2.3.4 Define load impedance

To obtain correct values in the power display (see 2.3.2), it is necessary to select the given impedance

according to your speakers (4 or 8 Ohms). This setting is only for calibrating the power display and has

no influence on the performance of the amplifier itself.