Aqua Creek Products F-734RSA 사용 설명서 - 페이지 3

{카테고리_이름} Aqua Creek Products F-734RSA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-734RSA 7 페이지. Revolution spineboard attachment

Install the spineboard attachment with the supplied clip pins as shown. Loop safety clips around

the back of the attachment tube and clip over the ends of the pins to keep them from slipping out

of the holes.

1. To load/unload the spineboard, rotate the tie-down clamps down, This allows the spineboard to slip

over the forks without interference.

2. Slide the spineboard under the hold-down bracket to ensure stability.

3. Make sure the forks are between the plastic blocks under the spineboard as shown at the bottom of

the following page (bottom view). This will keep the spineboard from sliding side to side.

4. Rotate the tie-down clamps up to capture the spineboard. Thread a tie-down strap through the top

hole and loop the strap around one of the spineboard handles. Loop the strap through itself and over

the top of the clamp. Loop the end over the strap as shown. Repeat for the second strap.

NOTE: The forks must be between the plastic blocks of the spineboard with the spineboard positioned as

shown at the bottom of the next page. DO NOT USE THE SPINEBOARD ATTACHMENT WITHOUT THE TIE-

DOWN STRAPS OR WITH THE PLASTIC BLOCKS REMOVED!

CLIP PIN (2)

Operating Instructions

Revised 9/15/17