AVM OVATION CD 6.2 사용 설명서 - 페이지 15

{카테고리_이름} AVM OVATION CD 6.2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVM OVATION CD 6.2 19 페이지.
AVM OVATION CD 6.2에 대해서도 마찬가지입니다: 사용 설명서 (19 페이지)

3 Advanced Settings

The personal setup offers a range of settings to individualize the CD 6.2 according to your

personal needs. To enter the personal setup menu, please switch off your device on the rear

of the unit at the mains switch (29). Keep the PROG button pressed (4) while you switch on

the unit again (29). As soon as the display shows the personal setup menu you can release

the PROG button (4).

When the personal setup is active you can select the desired function using the option keys

(2, 3). Use the SKIP buttons (13, 14) to apply changes to a selected function. EXIT exits the

personal setup and stores the settings.

Depending on the currently selected sound source the personal setup menu offers a range of

selected settings described in the following.

3.1.1

Set volume control

Gain fix

If the gain fix option is activated, the signal of the selected sound source will be played back

with a fixed volume level. This setting is particularly useful when the CD 6.2 is part of a

surround sound setup where a separate surround decoder is used for bass and multi-channel

management. If a surround system is connected to the CD 6.2, specific settings such as

channel balance, tone settings and bass management are controlled by a separate decoder.

These settings may not be altered by other components in order to maintain the balance of all

channels. For this application, the CD 6.2 offers the gain fix function by passing through the

signal with a fixed gain setting.

Gain variable

If the gain varibale option is activated, the volume level of the selected sound source can be

adjusted with the option keys (2, 3) on the front-side of the unit (see 2.6).

3.1.2

set display brightness

Sets display brightness 25% to 100%.

NOTE: The setting 100% can lead to "burn in" effects on the display if the unit is operated in

this setting for a very long time. In order to avoid such "burn in effects" please switch the unit

to stand by, if not in use.