Dexter Laundry T450 Express 소유자 책자 - 페이지 16
{카테고리_이름} Dexter Laundry T450 Express에 대한 소유자 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Dexter Laundry T450 Express 17 페이지. 30lb capacity computer control opl washer
Dexter Laundry T450 Express에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
11
The drive size setting has changed.
12
Washer controller internal error
13
The control cannot communicate with the drive Turn the power off to the washer. Check the data cable between the controller and the drive.
14
Over-current on the drive or motor.
15
Over-voltage on the drive or motor.
16
Overheating of the drive
17
Overload of the drive or motor
18
Ground Fault to the drive
19
Low Voltage to the drive
20
Internal drive error
21
Data error on communications between the
controller and drive
Note: Whenever power is turned off to the washer, it must remain off for one minute. The washer will not operate properly if this is not done.
Turn off the power to the washer. Check to ensure all the harnesses are properly connected
to the controller. Check to ensure the drive horsepower is proper for this size of washer. Turn
on power to the washer. (See Note) If problem reappears, contact your Dexter
representative.
Turn off the power to the washer. Wait one minute. Turn on the power to the washer. (See
Note) If problem reappears, contact your Dexter representative.
If no problem is observed, turn on power to the washer and test. (See Note) If problem
reappears, contact your Dexter representative.
Turn the power off to the washer. Check the washer motor to ensure it turns freely. Check
the wiring connections to the drive and motor. If no problem is observed, turn on power to the
washer and test. (See Note) If problem reappears, contact your Dexter representative.
Turn the power off to the washer. Check the washer motor to ensure it turns freely. Check
the wiring connections to the drive, braking resistors and motor. Measure incoming line
voltage. If no problem is observed, turn on power to the washer and test. (See Note) If
problem reappears, contact your Dexter representative.
Turn the power off to the washer. Allow the drive to cool. Check the cooling fins of the drive
to ensure proper airflow. Check the wiring to the drive including the fan wiring. If no problem is
observed, turn on power to the washer and test. (See Note) If problem reappears, contact
your Dexter representative.
Turn the power off to the washer. Check the washer motor to ensure it turns freely. Check
the wiring connections to the drive and motor. If no problem is observed, turn on power to the
washer and test. (See Note) If problem reappears, contact your Dexter representative.
Turn the power off to the washer. Check the wiring connections to the drive and motor. Check
the ground wiring of the drive, motor and incoming connection to ensure a proper ground is
present. If no problem is found, contact your Dexter representative.
Turn the power off to the washer. Check the wiring connections to the drive and motor. If no
problem is observed, turn on power to the washer and test. (See Note) Measure the incoming
line voltage. If problem reappears, contact your Dexter representative.
Turn the power off to the washer. Wait one minute. Turn the power on to the washer. (See
Note) If problem reappears, contact your Dexter representative.
Turn the power off to the washer. Check the data cable between the controller and the drive.
If no problem is observed, turn on power to the washer and test. (See Note) If problem
reappears, contact your Dexter representative.