AVM EVOLUTION C 5.2 사용 설명서 - 페이지 6

{카테고리_이름} AVM EVOLUTION C 5.2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVM EVOLUTION C 5.2 15 페이지.

Digital out

The input of a digital recorder must be connected to the digital outputs (26, 27). The signal on the

digital outputs depends on the selected source (build in CD, dig in etc.).

1.7 RC 3 remote control

The included RC 3 remote control allows for easy and comprehensive control of the C 5.2. All main

functions of the C 5.2 can be controlled by the RC 3: on/off, source selection, station selection, SKIP,

PLAY/PAUSE, and STOP.

By pressing the PLAY button briefly a second time, the PAUSE function is activated while in CD mode.

By pressing the STOP button briefly a second time, an inserted CD is ejected. By holding down one of

the SKIP buttons a little longer, the device switches into seek mode (fast forward/reverse).

Bottom view

Unscrew the 6 marked screws (CAUTION: Do NOT unscrew the 2 unmarked screws in the middle).

Take the bottom plate with the mounted pcb out. Remove the worn batteries and replace them with

two new batteries (type CR2032, 3V Lithium cells). Make sure that polarity is correct (the "+" sign must

be on top). Insert the bottom plate and screw it tight.

1.8

Connect the recorder's output to one of the inputs (17-19). The inputs of the recorder must be

connected to the fixed level output (20).

Aktiver Subwoofer ohne Frequenzweiche

If you use an active subwoofer (with built in power amplifier), simply connect it's inputs to the unit's pre

out (21) and adjust the bass level at the subwoofer.

The C 5.2 is equipped with two switchable speaker terminals (15 and 28) and thus allows either parallel

operation with two loudspeaker pairs or operation with respectively one of the connected loudspeaker

pairs. Both outputs can be activated or deactivated via the menu (see 3.1.6).

Connect your loudspeakers to the speaker terminals A (28) and B (15). Use only good speaker cables

with sufficient diameter. Make sure, that the red terminals are connected to the red or "+" terminals of

the speakers and the black terminals to the black or "-" terminals of the speakers.

Connect the antenna cable to the antenna socket (13).