Dextra AME2 M3 LS3 설치 리플렛
{카테고리_이름} Dextra AME2 M3 LS3에 대한 설치 리플렛을 온라인으로 검색하거나 PDF를 다운로드하세요. Dextra AME2 M3 LS3 2 페이지.
페이지 인쇄AME2 M3/NM3 LE3/LS3 Installation Leaflet
Voltage: 220-240V / 50-60Hz
LED Power: 4.5W (1W for NM3)
Output: 460 lm (160 lm for NM3)
Battery: Li-FeP04 18650 3.2V 1500mAh
Operating Temperature: 0°C - 40°C
BEFORE installation, the electrical supply and battery pack MUST be disconnected.
1.
Remove the diffuser by loosening the two screws.
3.
Drill out the cable entry point on the rear of the
housing. Ensure a suitable cable gland is used in order
to maintain the IP65 rating.
5.
Pass the cable through the cable gland, and wire
directly into the terminal block. Proceed to connect
the battery.
DIL-0300-0066
WARNING - THIS LUMINAIRE MUST BE EARTHED
This luminaire has been tested and is manufactured to comply with BS EN
60598 : specification for general requirements and tests. It should be installed by
a suitably qualified person in accordance with IEE.
CAUTION: there is a potential risk of electric shock from the LED boards when
the product is operational with the cover removed.
NOTE: INSTALLATION AND OPERATION OF THE LUMINAIRE BEYOND ITS
SCOPE OF SUPPLY WILL INVALIDATE THE WARRANTY.
2.
Release the tray by pushing the tabs outwards. Pull
the tray down, away from the body.
4.
Drill through the two fixing points on the back face.
Ensure the fixing points are adequately sealed in
order to maintain the IP65 rating. Secure the
6.
- M3
- NM3
Refit the diffuser to the body, and secure in place
Revision - B
luminaire with two screws.
using the two screws.
25/04/2022