AB Quality MicroLogix 1100 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} AB Quality MicroLogix 1100에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AB Quality MicroLogix 1100 12 페이지. Replacement battery

Installing Lithium Battery (1763-BA)

For battery installation or replacement do the following:

IMPORTANT

1. If you are replacing an old battery, unplug the existing battery connector. The figure

on page 10 shows the battery connector location.

2. Remove the battery from the retainer clips.

3. Insert a new or replacement battery in the holder making sure it is held in by the

retainer clips.

4. Plug the battery connector into the socket.

5. Secure the battery wires along the wire guide.

When the controller's Battery Low indicator is lit, check whether the

battery wire connector is connected correctly or replace the

replaceable battery with a new one immediately. When the indicator

turns on, it means that either the battery wire connector is

disconnected, or the battery will last for at most 2 weeks if it is

connected.

MicroLogix™ 1100 Replacement Battery

Publication 1763-IN003A-EN-P - August 2005