Avnet MSC C6B-KLH-7100E-NN0101C 설치 지침 - 페이지 4

{카테고리_이름} Avnet MSC C6B-KLH-7100E-NN0101C에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Avnet MSC C6B-KLH-7100E-NN0101C 4 페이지. Com express basic module. heat spreader

페이지 인쇄
Avnet MSC C6B-KLH-7100E-NN0101C 설치 지침
MSC C6B-SLH / KLH / CFLH / CFLR
Heat spreader mounting instructions
Step 1: Insert the memory module into the top memory socket. Make sure it is inserted correctly!
Note: When using only one memory module, insert it into the socket on the topside of the module.
Step 2: Place the printed circuit board onto the heat spreader and fix it by tightening the four screws in
the sequence 1 to 4 as shown below.
NOTE: The recommended screw tightening torque with a PH1 screwdriver is 0.4 Nm.
Step 3: Insert the memory module into the bottom memory socket if necessary.
Step 4: Mount the MSC C6B-SLH/KLH/CFLH/CFLR module on the baseboard and fix it securely with
adequate screws through the five mounting holes as defined in the COM Express Module Base
Specification. Please note that these screws are not provided in the delivery because there are different
mechanical implementation options like stacking height of COM Express receptacles on the customers'
carrier board.
There are two versions of heat spreaders in order to satisfy different mounting options needs, when
assembling module, heat spreader and baseboard.
On the C6B-SLH-01 HSP the five intended standoffs incorporate 2.7 mm though holes for screwing
through the top side of the heat spreader. On the C6B-SLH-02 HSP these standoffs incorporate M2.5
threads form screwing though the bottom side of the baseboard.
NOTE: The recommended screw tightening torque with a PH1 screwdriver is 0.4 Nm. It is also
recommended to use the full thread depth inside the standoffs (11mm).
NOTE:
The grey heat conducting pad is phase change material and intended for one-time mounting only. If you
need to remove the heat spreader for service purposes and want to reuse it, the wax-like material must
be spread over the full die surface before re-mounting the heat spreader (see above, paragraph 2).
4 / 4