Avnet Reach Further Ultra96-V2 매뉴얼 - 페이지 11
{카테고리_이름} Avnet Reach Further Ultra96-V2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avnet Reach Further Ultra96-V2 15 페이지.
페이지 인쇄3.2 Over-current Warning for Switcher A on Pmic 0x14
3.2.1 Applications Affected
Ultra96-V2 boards having a datecode of 1927 or earlier will exhibit this behavior.
3.2.2 Description
The Infineon Pmics used on Ultra96-V2 are programmable devices that include voltage value,
warning, and fault settings. Reference Designator U12 is an Infineon IRPS5401 with an address
setting of 0x14. Switcher A on this device delivers 1.8V to the Ultra96-V2 which is VCC_PSAUX.
this can be seen on Sheet 16 of Ultra96-V2 Rev 1 schematics. This rail was designed to deliver a
maximum steady-state current of 1.0A.
For the affected boards, the warning threshold was set too low, such that occasional current spikes
will trigger an over-current warning. This is only seen if actively monitoring in the Infineon
PowIRCenter software, as shown in the figures below. The warning does NOT affect the proper
operation of the board.
Figure 3 – Ultra96-V2 Schematic Page for Pmic #2, 0x14
Page 6