Aqua Flo AQUV AQUV-20R22 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Aqua Flo AQUV AQUV-20R22에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Flo AQUV AQUV-20R22 16 페이지. Ultraviolet disinfection system

페이지 인쇄

Unpacking the UV System

Your UV system includes the following items:

UV UNIT

Install Location

If your water comes from a well or a lake/river etc., the UV should be installed after your pump and pressure tank. To prevent damage to the UV

system, do not install it between well pump and pressure tank. If you have other water filters/conditioner installed, such as softener/iron filter etc.,

the UV system should always be installed as the last step of treatment before the water pipes divide into hot and cold (Fig 2).

Hot water

Cold water

to house

UV System

Water Heater

Fittings Required for Installation (Not Included)

Fittings required for a typical install on 3/4" copper pipe are 3/4" FNPT female adapters, 3/4" Tee, 3/4" Elbows, 3/4" copper pipe, 3/4" union

couplings and 3/4" ball valves. You may need different fittings if your pipe size or material is different. If you are unsure of what fittings to use,

please call Aqua Flo.

UV light can degrade plastics over time. If your water pipe is plastic (such as PEX), it is

recommended that you use at least 6 to 12 inches of UV-resistant material (e.g. copper)

on the inlet and outlet of the UV unit to prevent damage, and potential flooding.

Ballast with lamp

connector

Gland Nut

UV Lamp

Quartz Dome

Fig. 2

Water Meter

City Water

Well Water

Pressure Tank

Well Water

CAUTION

Ballast Mounting

Nut & Bolts

Ballast Mounting

Wrench

Fig. 3

Water

Flow

Dome O-Ring

(Thicker)

Lamp Spring

Gland Nut O-Ring

(Thinner)

Nut & bolts

Water

Flow