Aqua Flo AQUV AQUV-8R12 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Aqua Flo AQUV AQUV-8R12에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Flo AQUV AQUV-8R12 16 페이지. Ultraviolet disinfection system

Spring

8. From the top of the gland nut, drop the lamp spring into the quartz dome

Fig. 6C.

9. Holding the top 4-pin end of the lamp, carefully slide the lamp into the

quartz dome and attach the lamp pins to the lamp connector. The lamp

connector fits over the pins in only one orientation Fig. 6D.

10. Slide the lamp connector cover over the gland nut and tighten the screw

on it Fig. 6E. Check tightening details, the screw allows the cord to come through the plastic making it easy to hook up lamp, the white plastic

part has a little screw to secure it to the gland nut.

11. Remove the nut from the ground stud at the top of the unit. Next place the ground wire (green wire with yellow stripes) over the stud and

tighten the nut.

12. Connect the ballast power cable to the AC supply (with surge protector). The green lamp-on LED will light up and the display will show "365".

This number indicates the number of days left until lamp life expires and must be replaced. Follow Step (E) before consuming water.

YOUR AQUA FLO AQUV UV DISINFECTION SYSTEM IS NOW READY FOR SERVICE.

Fig.6C

Lamp

Fig.6D

WARNING

Installing lamp without the spring in place can cause

breakage of quartz dome.

Fig.6E