Aqua Flo AQUV-12 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Aqua Flo AQUV-12에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Flo AQUV-12 16 페이지. Ultraviolet disinfection system

CORRECT

Quartz dome is past gland

nut O-ring and is touching the

inside top end of the gland

nut. Caution: Do not push

hard as it can break the quartz

dome.

Thinner O-Ring

Quartz

Dome STOP

position

Thicker O-Ring

WRONG

Quartz dome is NOT past

gland nut O-ring and is NOT

TOUCHING the inside top end

of the gland nut.

Fig.5

10. Carefully slide the quartz dome with gland nut

attached into the opening at the top of the UV

chamber and hand-tighten the gland nut into

place.

CAUTION!

Do not overtighten the gland nut as it can

break the quartz dome.

Broken quartz domes are not covered

- Do not use pipe dope or tape on these top threads before

attaching gland nut.

11. Slowly open supply-valve and valves before and

after UV system. Check for leaks. Do not

proceed to next step until leaks are fixed.

12. From the top of the gland nut, drop the lamp

spring into the quartz dome.

13. Holding the top 4-pin end of the lamp

carefully slide the lamp into the quartz dome

and attach the lamp pins to the lamp connector.

The lamp connector fits over the pins in only

one orientation.

14. Slide the lamp connector cover over the gland

nut and tighten the screw on it.

NOTE

under warranty.