AB Slotsport AB OG12 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} AB Slotsport AB OG12에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AB Slotsport AB OG12 3 페이지.

Assemble the motor box overlay, rear pillar blocks

and rear spine mount / motor box key and solder in

place. Solder the Guide plate spacer and guide plate

in place.

Twin 0.032" rails. Both rails fit perfectly into the rear receports

which are designed to take 1/16" diameter tube. Rails at the

front solder into the existing front receptor and the front "lead

wire loop" slot.

Cut a further piece of 0.032" piano wire for the centre spine. This runs

from the rear centre spine mount / motor box overlay key to the back of

the guide plate spacer. Mount and solder the guide plate spacer and

guide plate, then solder in the centre and front spine mounts. Slide the

wire centre spine through the back, centre and front spine mounts and

into the slot in the guide plate. Solder the centre spine to all 3 mounts and

the guide plate.You may wish to use "slick 7 type" 0.032"Pin tube Top

hats each side of the centre spine mount plates to ensure rigidity. (S7#

S7140).

Solder rails together a maximum of 0.50"

Note;- The centre spine "falls"

from the rear to the centre spine

mount & again to the guide

plate. Ensure you use the "High-

er" Spine mount in the centre

and the lower one as the front

mount.