Avocent DSR Series DSR8030 펌웨어 릴리스 노트 - 페이지 2

{카테고리_이름} Avocent DSR Series DSR8030에 대한 펌웨어 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Avocent DSR Series DSR8030 3 페이지. Avocent dsr series dsr1030: install guide
Avocent DSR Series DSR8030에 대해서도 마찬가지입니다: 하드웨어 사양 (2 페이지), 릴리스 노트 (3 페이지), 펌웨어 릴리스 노트 (3 페이지), 펌웨어 릴리스 노트 (3 페이지), 릴리스 노트 (3 페이지), 사양 (2 페이지), 빠른 설치 매뉴얼 (8 페이지)

페이지 인쇄

=============================================================================

This release contains the following enhancements:

1. Added support to disable the local port OSCAR® graphical user interface (GUI) configuration

buttons (Setup, Commands, and Clear) via DSView 3 software.

Note: This feature requires DSView 3 software version 3.6 or later.

2. Added support for "auto-discovery" to enable the DSR switch to register itself with DSView 3

software as an "unmanaged" device.

Note: This feature requires DSView 3 software version 3.6 or later.

3. Optimized the DSR switch's video mode detection algorithm to detect the target device's video

mode and display remote video more quickly so the user can see the POST (Power-On Self Test)

and BIOS screens on faster booting computers.

4. Added support to dynamically enable and disable secure mode on a DSR switch from DSView 3

software. Previously, this required removing the switch from DSView 3 software and adding

again.

Note: This feature requires DSView 3 software version 3.6 or later.

5. Added support for the Avocent iKVM switch integrated into the Dell® PowerEdge® M1000e

Modular Blade Enclosure to provide seamless access to each of 16 server blades and the Dell

Chassis Management Controller (CMC).

Note: The iKVM switch may require a firmware update to support this functionality.

6. Updated the Onboard Web Interface (OBWI) help link to point to an online version of the user

manual.

=============================================================================

This release contains the following fixes:

1. Resolved issue where target devices on an AutoView® switch cascaded via the RJ45 ACI ports

from a DSR switch could not be selected from DSView 3 software.

2. Resolved usability issues in the OSCAR GUI IP Setup screen to allow the user to leave the

gateway field blank to specify no default gateway.

3. The IP address fields on the serial setup console's network configuration menu are now hidden

when the IP configuration is set to "None."

4. Resolved issue where a DSR switch in IPv6 mode is removed from DSView 3 software; the switch

was left in secure mode preventing it from being discovered by another DSView 3 software

system.

5. Resolved issue on DSR8020 and DSR8030 switches where the local port user could not connect

to a target device if four (4) unshared remote KVM sessions were active.

Enhancements

Fixes