DeZurik APCO 100SR 설치, 운영 및 유지보수 매뉴얼 - 페이지 10

{카테고리_이름} DeZurik APCO 100SR에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DeZurik APCO 100SR 14 페이지. Rubber flapper swing check valves

DeZURIK

APCO CRF Rubber Flapper Swing Check Valves

Spring Return Attachment Option

The Series 100SR is designed to minimize or eliminate slam in high head applications where rapid flow

reversal causes standard swing check valves to slam. This valve has a 35° disc stroke as compared to

conventional style swing check valves, which typically have between 80° to 90° disc travel. Adding a

spring return feature causes the disc to speed up or accelerate valve closure. Having the valve closed

before reverse flow occurs can in many instances drastically reduce or even eliminate valve slam.

Note: Pump does not require shutdown or to be depressurized to make spring adjustments.

To Increase Closing Speed:

Remove Spring Cover (54), See Figure 6.

1. Loosen Adjusting Screw Lock Nut (58), and then turn Spring Adjusting Screw (57) clockwise.

This will increase the compressive load on the spring (63), as well as apply more pressure on

the flapper to cause it to close faster and reduce slam.

2. Lock the Adjusting Screw with the Lock Nut when desired setting has been reached.

To Decrease Closing Speed: (Minimize head loss and increase flow rate)

1. Remove Spring Cover (54), see figure 6.

2. Loosen Adjusting Screw Lock Nut (58), and then turn Spring Adjusting Screw (57)

counterclockwise. This will decrease the pressure of the flapper-hence, minimize head loss and

increase flow rate.

3. Lock the Adjusting Screw with the Lock Nut when desired setting has been reached.

There are very few moving parts in this valve – a spring adjusting mechanism where all components

are made of stainless steel, and a rubber flapper. This valve requires virtually little or no maintenance.

For periodic inspection of the rubber flapper and the body seat surface, the following procedures may

be taken: Refer to Figure 6 for details and parts.

Servicing the valve while the pipeline is under pressure can cause personal injury or

equipment damage. Relieve pipeline pressure before servicing the valve.

1. Relieve the pressure in the pipeline.

2. Isolate the Rubber Flapper Check Valve from system before loosening the Cover Bolts (4) to

remove the Cover (2).

3. Loosen each cover bolt only three full turns, then tap the side of the cover with a mallet to

separate only the valve cover from the Cover Gasket (3), this will relieve any pressure in the

valve.

4. Continue loosening to remove all cover bolts and lift off the cover. After removing the cover, the

Flapper (10) will be fully exposed and freely removed. At this point, the flapper and body

surfaces should be examined for wear.

D12007

Page 10

December 2012