Avocent ACS 6000 빠른 설치 매뉴얼
{카테고리_이름} Avocent ACS 6000에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avocent ACS 6000 20 페이지. Advanced console server
Avocent ACS 6000에 대해서도 마찬가지입니다: 릴리스 정보 (4 페이지), 릴리스 정보 (5 페이지), 릴리스 정보 (5 페이지)
페이지 인쇄
QUICK INSTALLATION GUIDE
SECURITY WARNING
The ACS 6000 advanced console
server provides extensive access
to the devices attached to this
equipment. As a result, care must be
taken to avoid compromising your
security policies.
From the factory, this equipment is
shipped with the following settings:
• DHCP, Telnet, SSH v1 & SSHv2,
HTTP & HTTPS – ENABLED
• All Serial, USB and AUX ports –
DISABLED
• Ethernet and Console Port –
ENABLED
• PCMCIA Drivers – DISABLED
• Two Default Users with passwords:
– root – linux
– admin – avocent
• Shell Access for root and admin
– ENABLED
Avocent strongly recommends that
you change the default password
and carefully select a Security Profile
immediately after initial setup.
Please consult the Installation/
Administration/User Guide for more
information on Security Profile
selections.
For manual downloads, visit:
www.avocent.com/manuals
The following instructions will help you
install your console server.
Should you require further assistance,
please contact Avocent Technical Support.
To Contact Avocent Technical Support: Visit www.avocent.com
Avocent and the Avocent logo are registered trademarks of Avocent Corporation or its affiliates in the U.S. and other countries. ©2009 Avocent Corporation.
ACS 6000
Advanced Console Server
ACS 6016 console server shown
PDU
1
Rack mounting the console server
For detailed rack mounting instructions,
see the ACS 6000 Installation/
Administration/User Guide.
Connecting to your network
2
Connect an Avocent-recommended
CAT 5e or CAT 6 cable from the
10/100/1000BaseT port to your network.
You may connect to either or both
network ports for redundancy.
5
Optional DC, Dual AC
or Dual DC power
3
AUX or modem port
2
2
6
RJ-45 console
adaptor
Console user
Connecting devices
3
Using CAT 5e or CAT 6 cables and DB9
or DB25 console adaptors, connect the
appropriate serial and power devices to
the serial ports on the console server.
Connecting USB, PMCIA and
4
CardBus devices
Connect a supported USB, PCMCIA
or CardBus device to the appropriate
ports located on the front of the console
server.
7
590-769-629C