DeZurik G-SERIES 매뉴얼 - 페이지 13

{카테고리_이름} DeZurik G-SERIES에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DeZurik G-SERIES 16 페이지. Lift, turn and reseat used on ptw & pfw tapered plug valves
DeZurik G-SERIES에 대해서도 마찬가지입니다: 지침 (7 페이지), 매뉴얼 (8 페이지), 매뉴얼 (17 페이지), 매뉴얼 (14 페이지), 매뉴얼 (12 페이지), 매뉴얼 (14 페이지), 지침 (19 페이지), 매뉴얼 (17 페이지), 사용 설명서 (13 페이지), 매뉴얼 (9 페이지)

페이지 인쇄
DeZurik G-SERIES 매뉴얼
Reassembling Actuator
7. Place a new gasket (B26) on the cylinder head.
8. Install the cylinder/rack rod assembly by sliding the rack rod through the rack (B4) and fasten
the cylinder to the housing (B1) with screws (B27).
NOTE: If the rack rod is not attached to the cylinder assembly, clean the threads of both the rack rod and
the cylinder shaft, then apply Loctite to the cylinder shaft threads and screw the rack rod onto the cylinder
shaft.
9. Slide the spring washers (B21) and screw the jam nut (B22) onto the rack rod (B6) until the
spring washers are completely compressed, then loosen the jam nut just until the spring
washers return to normal shape. See Table C for spring washer arrangement.
August 2012
(Continued)
Figure 8 – Gear and Rack Alignment
Page 13
Cylinder Operated G-Series Actuator
DeZURIK
D10455