DeZurik G6-C4 매뉴얼 - 페이지 12

{카테고리_이름} DeZurik G6-C4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DeZurik G6-C4 16 페이지. Cylinder operated actuator

DeZURIK

Cylinder Operated G-Series Actuator

Reassembling Actuator

Install new bearings (B12) if required and O-rings (B14) in the housing (B1) and cover (B2) if

necessary. See Figure 7 for proper placement.

1. Scrape old gasket material from the housing (B1), cover (B2) and stop cap (B29).

2. Line up the scribe marks on the adaptor plate (P1) and actuator housing (B1) made during

actuator removal, then set the actuator housing on the adaptor plate.

3. Fasten the actuator housing (B1) to the adaptor plate (P1) using screws (P2) and lockwashers

(P3).

4. Align pin (B11) to rack bearing (B7) pinhole and install. (Install new rack bearing if there is

noticeable wear.)

5. Apply a liberal amount of lubricant to the teeth and back of the rack (B4) which contacts the rack

bearing (B7) and install the rack in the housing (B1).

6. Apply a liberal amount of lubricant to the teeth and journals of the gear (B3), then place the gear

in the housing (B1) and carefully align the teeth with the rack as shown in Figure 8.

NOTE: It may be necessary to loosen the adapter mounting screws and move the housing a small

amount to align the gears. Be sure to retighten the mounting screws after aligning the gears.

D10455

Figure 7 – Bearing and O-ring Locations

Page 12

August 2012