Aqua Lung Conshelf XIV 사용자 설명서 - 페이지 13

{카테고리_이름} Aqua Lung Conshelf XIV에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Lung Conshelf XIV 20 페이지.

Removing the DIN Connector from the Cylinder Valve

1. Turn the DIN handwheel clockwise to loosen and remove the first stage from

the cylinder valve.

2. Dry the protector cap with a towel or other lint free cloth. While you may use

air from your cylinder valve to blow the water off the dust cap, you run the risk

of blowing water into the filter.

3. Place the protector cap over the first stage threaded inlet fitting and seal it

securely in place by turning the DIN handwheel counter-clockwise.

4. With the cylinder valve facing away from you, open the valve slightly to release

a short burst of air, and then immediately close the valve. This will clear any

moisture that may have entered the valve opening. Immediately seal the protector

cap over the opening of the valve to prevent the entrance of moisture or debris.

It is important to provide the proper preventative maintenance in order to ensure

the best possible performance and maximum life of your Aqua Lung Regulator.

The following maintenance procedures should be performed routinely after each

use to ensure that the regulator is cleaned, inspected and prepared for the next

use or for storage.

Aqua Lung America recommends that the second stage regulator be disinfected

periodically using an FDA approved solution.

As soon as possible after diving, the regulator should be rinsed thoroughly with

fresh water while it is attached to a cylinder and pressurized with air.

Rinsing alone, however, will not sufficiently clean the regulator. To clean the regulator

as thoroughly as possible, Aqua Lung recommends using the following procedures:

CAUTION:

screw or DIN handwheel if the regulator is submerged unpressurized.

Doing so will allow the entrance of moisture and will require that the

regulator be returned to an Authorized Aqua Lung Technician for service.

DO NOT depress the purge button, loosen the first stage yoke