Aqua Lung Calypso 서비스 매뉴얼 - 페이지 6

{카테고리_이름} Aqua Lung Calypso에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Lung Calypso 19 페이지. Second stage
Aqua Lung Calypso에 대해서도 마찬가지입니다: 기술 게시판 (4 페이지), 사용자 설명서 (20 페이지), 유지 관리 매뉴얼 (20 페이지)

페이지 인쇄

RE-ASSEMBLY PROCEDURE

If the exhaust valve has been removed, pass the valve

tail through the hole in the casing from the outside and

pull gently until the notch is inside the casing. If it is a

new valve cut off any excess tail leaving about 5mm.

2. Fit a new O-ring (7) into the groove on the venturi knob

(6) and in the groove on the crown holder (22).

3. Fit the O-ring (20) onto the seat (21)

4. Insert the seat(21) into

the crown holder (22).

Use tool 125727 to screw

the seat fully home

against the crown holder.

Service manual Calypso second stage

5. Fit a new seat into the crown holder.

7. Fit the seat into the crown holder. This is to avoid

damaging the new crown. Screw the crown holder assembly

onto the insert (15) fitted with the poppet.

6. Fit a new square

poppet (16) using the

crown holder (18); then fit

the spring (17) into the

insert (15), then the

poppet (18).

8. Fit the lever (14).

The lever should be

opposite the injection

hole.