Aqua Lung CALYPSO FIRST STAGE 기술 유지보수 매뉴얼 - 페이지 5

{카테고리_이름} Aqua Lung CALYPSO FIRST STAGE에 대한 기술 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Lung CALYPSO FIRST STAGE 16 페이지.

Calypso First Stage Service Manual

Remove the o-ring (16) from the inlet fitting (17). Insert the

extraction tool through the center hole of the inlet fitting and

push out the conical filter (14).

Remove the recessed

o-ring (15) from the inside

of the inlet fitting (17).

Turn the regulator in the vise so that the end cap (2) faces

up. Using a large crescent wrench, remove the end cap.

Remove the vise mounting tool.

Insert the handle end of the extraction tool into the threaded

end of the body (8) and push out the crown orifice (12).

Remove the o-ring (11) from the crown orifice.

Remove the main spring (7) from the piston cap (2). Firmly

grasp the shaft of the piston (4) and directly pull it out of the

cap.

10.

Remove large piston head o-ring (3). Remove piston shaft

o-ring (5).

11.

Insert the extraction tool

through the head of the

piston (4) and push out

the piston HP seat (6).

This Ends Disassembly

Before starting reassembly, perform parts

cleaning and lubrication according to the

procedures outlined in Procedure A, titled

Cleaning & Lubrication, on page 12.