Avocet 45tt 매뉴얼 - 페이지 10

{카테고리_이름} Avocet 45tt에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avocet 45tt 13 페이지.

3. CADENCE MAGNET AND PICKUP.

on the inside of the left crank arm about 3 inches from the pedal. Align the crank with the left

chainstay and mount the pickup on the bottom of the left chainstay opposite the magnet. Run the

wide tie through the slot in the pickup and wrap its loosely around the chainstay.

To position the pickup, slide it backward or forward on the chainstay until its alignment notch is

opposite the alignment ridge on the magnet. Then rotate the pickup upward until the gap be-

tween the magnet and pickup is 1.5 mm to 5 mm. After aligning the pickup, pull the tie tight and

trim its end.

Rotate pickup until gap is 1.5 mm to 5 mm

Gap

Crank arm

Magnet

Attach the cadence magnet with a cable tie

Pickup

Magnet

Chainstay

Pickup

Alignment

ridge

Alignment

notch

chainstay with ties gathering any excess under one of the ties. Run the cadence wire from under the

bottom bracket shell and up the underside of the down tube. Secure the wire with ties, then run it up

the brake cable wrapping excess wire around the cable. Leave enough slack in the wire between the

frame and the brake cable that the handlebars turn all the way in both directions. Install the mount

on the handlebars as described on page 22.

Cable Housing

Cadence Wire

Down Tube

Attach the receiver wire to the inside of the

BE SURE THAT CADENCE

IS TURNED ON–

SEE SETUP

Receiver wire

Chain stay

Cadence pickup

Bottom bracket shell