Avocet 45tt 매뉴얼 - 페이지 6

{카테고리_이름} Avocet 45tt에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avocet 45tt 13 페이지.

TIMER.

continues timing. Press the left button to start and stop the Timer. Reset

by pressing both buttons or by global reset. Reset also stops the Timer.

You can time parts of your ride without affecting the average speed of

the entire ride, because Average Speed is calculated from Riding Time

that has its own timer.

CLOCK.

colon between the hours and minutes in the Clock flashes to distin-

guish it from the Timer.

time, hold down the left button when the timer is displayed. The Riding

Time function shows the time and distance that have been used to com-

pute average speed. Dividing the Riding Distance by Riding Time gives

your average speed. Resetting Average Speed resets Riding Time and

Riding Distance. By resetting Average Speed during a ride, you can use

this function to split out time and distance for a part of a ride.

Riding time only accumulates when the wheel is turning. Before an

event with a standing start, you can reset Average Speed and timing will

begin automatically when the wheel turns. Also, with time and distance

displayed together, you can easily ride to a schedule. For example, if you

set a goal of two hours for 40 miles, Riding Time will show you how

much ahead of schedule or behind schedule you are as you progress

through the ride.

The Timer displays times to 9:59:59 then rolls over to 0 and

The Clock can be set up in either 12 or 24 hour format. The

for 8 seconds until 'mi' or 'km' appears. Press the left button to switch

between miles and kilometers. Stored speed and distance data are auto-

matically converted to the units chosen. After selecting units, press the

right button to go to calibration.

You can change from miles to kilometers for a specific ride such as a 40

km time trial or for a trip to a country where the metric system is used.

Your accumulated miles will be converted and not lost. You can also change

To reach riding

during a ride to see how fast you are going in km/h and how many kilo-

meters you have travelled. To change, hold both buttons in any function

until 'mi' shows. Press the left button to show 'km', then press the right

button until you have exited setup.

When the Cyclometer displays kilometers, the Gear-Inch function be-

comes Development in centimeters. Development is the distance trav-

eled by the bicycle with each revolution of the crank and is the European

standard for expressing gear size.

PART III–SETUP

To reach setup hold both buttons

Step 1