DFG E-TitanComb 사용 설명서 - 페이지 3
{카테고리_이름} DFG E-TitanComb에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DFG E-TitanComb 5 페이지. Heavy duty binding machine digital finishing group
페이지 인쇄A
Picture 1
B
Picture 2
Determine Plastic comb binding element size
There are three methods you can use:
1. To use any size of comb you like, as long as the comb size is larger than book
thickness2.
2. To use coil that is 2 – 6 mm (1/8" to ¼") larger than book thickness
3. To use our coil size selector. Please refer to the picture 3 (EtitanCoil machine
showed. only comb size up to 1 1/2" are showed)
Picture 3
1260 Kempar, Madison Heights, MI 48071, U.S.A. Phone: 248-733-0400, Fax: 775-587-5352
Email: [email protected] Website: www.dfgus.com
Installation
1. Remove a screw (A) from binding shaft (see
picture 1) by a Philip (cross) head screwdriver.
2. Push binding handle (B) onto the binding shaft
(see picture 2).
3. Install the screw back
Put book on the table and under the
"Size Selector".
Move the "Size Selector" down until
its bottom touches the top page of
sheet.
The point area of the "Size Selector"
will point the coil size you can use