Fender 215 PRO 서비스 매뉴얼 - 페이지 4

{카테고리_이름} Fender 215 PRO에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fender 215 PRO 11 페이지.

Input Assembly removal is required for lamp re-

placement and is accomplished by following these

steps:

1. Remove the four screws from the input panel

corners.

2. Pull the panel out at the top until the L-pad is

clear of the mounting plate, then pull upward on

the assembly.

PCB EXCHANGE POLICY

Parts marked with a single asterisk (

Lists are not field replaceable. If a failure due to

one of these components is detected, please con-

tact the FMIC Customer Service Department to

order the complete PCB Assembly.

SERVICE NOTES

) in the Part

(This is the model name for warranty claims)

3. Use a small screwdriver or other tool to remove

the blown lamp, which is visible through a cut-

out in the circuit board.

4. Remove the spare lamp stowed on the side of

the circuit board and install it where the blown

lamp was removed.

5. Install the input assembly in the reverse order

of removal.

215 PRO