Aqua Medic aquastarlight T5 운영 매뉴얼 - 페이지 7

{카테고리_이름} Aqua Medic aquastarlight T5에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Medic aquastarlight T5 8 페이지. 92 cm 4 x 39 w 122 cm 4 x 54 w 152 cm 4 x 80 w

페이지 인쇄

Stainless steel cable

Now, the stainless steel cable is fed through the retaining bush (2) of the ceiling plate so that the

stopper (3) is placed inside the ceiling plate. The retaining bush is screwed onto the ceiling plate

allowing the stainless steel cable to hang free.

Fixing of the lamp:

First of all, the plug respectively screw covering the holes of the suspension has to be removed.

Both lamp fixings (5) have to be screwd into those holes. Caution: Ensure that the plastic washer

(8) is placed inbetween.

The stainless steel cable is fed through the lamp fixing from the top (6). It comes out of the lateral

opening (7) and then it has to be pulled out and adjusted to the correct height above the

aquarium.

Release the fixing:

The lamp fixing has got a non-return mechanism so that the cable can be adjusted easily. To

remove the lamp or adjust height put one finger on the fixing screw (6). Caution: Hold the lamp

tight! Now, the cable can be removed from fixing.

When the lamp is mounted to the correct height any surplus cable may be cut off.

Pay attention to the required minimum distance of 30 cm to the water surface!

Electrical connection:

The aquastarlight can be connected to any safety socket or to a timer if automatic operation is

requested.

Fig. 1: Fixing of the stainless steel cable

1. Ceiling suspension

2. Retaining bush of the ceiling plate

3. Stopper on the stainless steel cable

4. Stainless steel cable

5. Lamp fixing

6. Fixing screw for releasing

7. Cable's end

8. Distance ring

a q

u a

s t a

r l i

g h