ALLIED MEDICAL Ki Mobility Catalyst 5 설정 매뉴얼 - 페이지 9

{카테고리_이름} ALLIED MEDICAL Ki Mobility Catalyst 5에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLIED MEDICAL Ki Mobility Catalyst 5 11 페이지.

Adjusting Anti-tipper Height

1. Press in the detent button (C) to move the lower assembly (D) up or down.

2. Determine appropriate height from the holes available, install and ensure the detent buttons

"click" and lock into place

3. Ensure the height is set the same on both sides

Adjusting Catalyst Performance Castor Housing

1. Remove footrest for ease of adjustment

2. Take protective cover off the castor housing by pulling straight up

3. Using a 5mm Allen key turn each screw on the outside of the castor housing anti-clockwise

two complete rotations to loosen.

4. Locate the adjustment screw on the top of the top of the castor housing. Using the 5mm

Allen key turn the screw clockwise to move the castors forward away from the rear wheel.

Turn the screw anti-clockwise to move the castors rearward towards the rear wheel.

5. Keep turning the screw in the direction necessary to re-square the castors

6. Use a square against the front of the castor barrel check for castor squareness. Re-adjust if

necessary and recheck.

7. Re-tighten both screws on the outside of the castor housing until secure and replace the

cover.

8. Repeat steps on opposite side

See link for video on Performance Catalyst castor housing:

https://vimeo.com/149441646

For standard Catalyst castor housing – see link for video:

https://vimeo.com/149444977