Avonic CM-CON100 사용자 설명서 - 페이지 11
{카테고리_이름} Avonic CM-CON100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avonic CM-CON100 13 페이지. Ptz camera controller
Avonic CM-CON100에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (11 페이지), 사용자 설명서 (16 페이지)
페이지 인쇄
The controller can also batch program cameras in the system. It will set the same baud rate,
protocol for the 10 cameras next to the current one while the cameras' address to be increased by
increment number sequentially. After step 5, press SHIFT to enter menu "INCREMENT:" Input a
number within 1~20, press ENT to confirm.
The address increment between two sequential cameras. For example, the current camera
address is 1 and the increment is 2, then the next camera address is 3.
Time Setting
Set time in 24 hour
format.
Volume Setting
Backlight Setting
Sleep Setting
PIN setting
【Note】In non-menu status, quickly lock function can be realized by
simply pressing
required for operation the controller again.
Joystick calibration
Pan left
Pan right
Tilt up
Tilt down
Zoom tele
Zoom wide
Free state
www.avonic.eu
TIME SETTING
10：52：59
VOLUME SETTING
BACKLIGHT MODE
SLEEP SETTING
PIN SETTING
. "USER PIN"or "ADMIN PIN" is
+
SHIFT
ENT
JOYSTICK CALIB
PAN LEFT
PAN RIGHT
TILT UP
TILT DOWN
ZOOM TELE
ZOOM WIDE
FREE STATE
11
OFF (switch off sound)
1~6 (6 levels from low
to high)
AUTO/ON/OFF
OFF/ 30S/ 1M/
5M/10M / 30M/60M
USER/ADMIN
After long-time use,
the joystick may
require calibration
Move the joystick to
left limit and press
ENT
Move the joystick to
right limit and press
ENT
Move the joystick to
upper limit and press
ENT
Move the joystick to
lower limit and press
ENT
Twist the joystick
clockwise to the limit
and press ENT
Twist the joystick anti
clockwise to the limit
and press ENT
Need not any
operation, press ENT