CP Electronics EBDSPIR-AD 제품 설명서 - 페이지 7
{카테고리_이름} CP Electronics EBDSPIR-AD에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CP Electronics EBDSPIR-AD 13 페이지. Ceiling pir presence detector – 1-10v dimming
CP Electronics EBDSPIR-AD에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)
페이지 인쇄
When power is applied to the unit, the load will turn on immediately.
Set the timeout to 10 seconds, vacate the room or remain very still and wait for the load to switch off .
Check that the load switches on when movement is detected.
The unit is now ready for programming.
What if the load does not turn ON?
Check that the live supply to the circuit is good.
Check that the load is functioning by bypassing the sensor (e.g. link terminals L and L/ Out on Channel1).
If the detection range is smaller than expected, check the diagram on page 2. Rotating the sensor slightly may
improve the detection range.
HINT: The Walk Test LED function can be used to check that the unit is detecting movement in the required area.
What if the load does not turn OFF?
Ensure that the area is left unoccupied for longer than the Time Out Period.
Ensure that the sensor is not adjacent to circulating air, heaters or lamps.
Power-up test procedure
Fault finding
7