Avonic AV-CD500 사용자 설명서 - 페이지 13

{카테고리_이름} Avonic AV-CD500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avonic AV-CD500 19 페이지.
Avonic AV-CD500에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

MOUNTING AND INSTALLATION

The CD500 is a hardware unit and part of the

to perform to mount and install the CD500 in a correct and safe manner.

These steps are subdivided into the following groups, each of which is described in a separate section:

1. Mounting on a wall using the mounting shields

2. Connecting the Components to the CD500

Take the following precautions to prevent the CD500 from falling down which may cause injuries:

• Set up the Product on a hard, stable surface, or mount it to a wall or ceiling.

• ONLY use an Avonic mount for mounting to a wall or tripod.

• Ensure the mounting construction is capable of supporting four times the weight of the Product. (See

'General Specifications > Weight product' in the CD500 Datasheet for the exact weight.)

• Use a safety loop or drop protection that prevents the Product from falling if the mounting construction fails.

• During mounting and installation, NEVER install the Product above a person.

• Check the installation at least once a year. An improper mounting could cause the unit to fall off, resulting in

personal injury.

It is also possible to mount the CD500 using the delivered mounting shields to a wall.

Follow instructions below:

1. The mounting shields are already connected to the CD500. Use the supplied screws (4) and place for

every screw hole 2 spacers. The spacer with a cut should be above the spacer without a cut.

2. Connect the bottom of the mounting shield to a wall using the screws. See the pictures below.

CamDirector

(system). This chapter describes the steps you have