CP Electronics Ellipse/TN 제품 데이터 및 설치 시트
{카테고리_이름} CP Electronics Ellipse/TN에 대한 제품 데이터 및 설치 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. CP Electronics Ellipse/TN 2 페이지. Time lag switches
페이지 인쇄PRODUCT DATA AND INSTALLATION SHEET
ELLIPSE
KH2 E
AND
T
L
S
IME
AG
WITCHES
ELLIPSE
Push button activated time lag switch
W
IRING
Conventional Wiring
Wire the units as in diagram 1. When using multiple switch posi-
tions see diagram 2.
For two way and intermediate switching follow the diagrams over-
leaf. Note that as long as each switch position has a Live feed
and a Live Out connection to the load then the switch will be
properly wired.
Diagram 1
Conventional
wiring
Diagram 2
Multiple switch
locations
LECTRONIC
KH2
Touch activated time lag switch
D
ESCRIPTION AND
The ELLIPSE and KH2 time lag switches are a quick and effective
way to reduce energy consumption for lighting applications. Press-
ing the button or touch pad brings the lights on; the lights will then
switch off automatically after a preset time period has elapsed.
These units do not require a neutral connection, therefore they can
be used to replace an existing light switch. The duration of the time
delay is set by a thumbwheel on the reverse of the unit.
The ELLIPSE/TN and KH2N have neon illumination to allow the
unit to be located in the dark.
Time lag switches can be used in two way and intermediate switch-
ing arrangements without any extra wiring.
I
NSTALLATION
Warning. This device works at mains potential. Be sure to take care when
working with electricity.
1.
Make sure the load is connected and in working order.
2.
Isolate the mains supply to the circuit at the main consumer unit.
3.
Connect the controller via the terminal block. Live supply to the L
terminal and the load to the LIVE OUT terminal.
4.
Push the override switch to the off position (see diagram).
5.
Set the timing range using the thumbwheel. Turn clockwise to
increase timing.
6.
Screw the unit to the wall and switch the mains supply back on at
the distribution board.
7.
Wait 20 seconds before pushing the button
8.
Push the button or touch pad and the lights will come on
9.
Wait for the time period and the lights will turn off again.
O
PERATION
Ref %WD124 Issue 3