Billi B-4000 사용자 설명서 - 페이지 11

{카테고리_이름} Billi B-4000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Billi B-4000 13 페이지. Instant boiling and ambient filtered water system
Billi B-4000에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지)

페이지 인쇄

User guide

B–4000.

Filter removal and replacement

instructions

1. Remove the front panel, see Diagram 1.

2. Place the unit in Holiday Mode by pressing

the Pressure Relief button once. The lights

on the dispenser will alternate and then go

off, see Diagram 2.

3. Hold filter and swing towards you slowly.

The top of the filter is in a hinged cradle

assembly. It should stop after approximately

30 degrees of travel, see Diagram 3.

4. The filter can now be released from the

holding cradle by pulling down on the filter.

5. Take care not to spill water in the base of the

tray. If so wipe gently with absorbent paper.

6. Install new filter into the same location by

pushing all the way up into the cradle.

7. Push filter back into the unit until it locks

into place. Power light should come back on.

8. Lift ambient lever and run water for 3

minutes.

9. Check for any leaks from around the filter,

hosing or pipeworks.

10. Replace the front cover.