Billi XI Slimline Font 설치 매뉴얼 - 페이지 3
{카테고리_이름} Billi XI Slimline Font에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Billi XI Slimline Font 8 페이지. Proud & flush mount
페이지 인쇄Installation procedure.
Proud Mount
1. Marking and Drilling Holes
a. Cut out hole in benchtop using
measurement shown in Diagram 7a on
the following page.
2. Fitting Drain Adapter
a. Fit O-ring to Drain adapter.
b. Fit Drain adapter to tray. Tighten M5
screw, Note: Do NOT over-tighten
the screw.
c. Drain tube and elbow fitting are to
face dispenser mount hole – refer to
diagram 1 on previous page.
3. Fitting Billi Font to Benchtop
a. Install the sealing gasket around the edge
of the font tray. Refer to Diagram 2.
b. Lower the Font tray into the cut out and
insert 4 x M6 bolts, one in each corner.
c. Fit the clips and M6 Flange nuts to all 4
bolts – refer to Diagram 3.
e. Tighten nuts until rim sits flat on
benchtop. Do NOT over-tighten nuts.
4. Fit front and rear cover plates
a. Remove protective film from cover
plate set.
b. Remove bottom gasket covers and insert
into gasket grooves.
c. Remove gasket cover and insert cover
into font tray.
d. Ensure holes in rear cover plate align with
the holes in the font tray.
e. Apply pressure around edge of plate(s)
to ensure proper gasket seal.
5. Install the tap – refer to diagram 4.
a. Feed the dispenser tube and tap base into
hole in the rear of the font.
b. Feed lock mechanism components onto
the end of the dispenser tube in the
following order:
i. Washer
ii. Locking bush
iii. Locking nut.
c. Slide components into position and
tighten the locking nut.
Note: Do NOT over tighten.
6. Connect Tubing to Underbench Module
a. Connect dispenser tubing to underbench
module as per installation instructions
supplied with your unit.
7. Connect Drainage
a. Connect drainage tubing with reference
to Drainage Requirement instructions
on previous page. Drainage tube must
be installed with a continual fall along
the entire length of the tube and must be
adequately clipped and supported.
Bench
Seal between
Font and Benchtop
Diagram 2
Bench
Clip
Bench
291mm
Font tray
Font tray
M6
Bolt
Diagram 3
Plate
Gasket
Font tray
Washer
Locking Bush
Locking Nut
Diagram 4
191mm
Diagram 5
3