Aqua One Oakstyle 230 조립 지침 매뉴얼 - 페이지 15
{카테고리_이름} Aqua One Oakstyle 230에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua One Oakstyle 230 18 페이지.
페이지 인쇄
Step 27
Fit the Plastic Nails
Tap 2 Plastic Nails into
the bottom edge of each
of the Sides.
Tap a Plastic Nail into
the centre of the bottom
edge of the 2 Plinths and
the Back.
Step 28
Secure the unit to a
wall
a:
Before fitting the unit
to a wall, use a spirit
level to check the top of
the unit is level,
front-to-back and
side-to-side in the 3
positions shown.
Use suitable packing
pieces (not supplied) to
make the unit level.
To prevent possible
overbalancing this unit
must be secured to a
suitable wall by fitting the
2 Overbalance Protector
Kits to a wall.
b:
Push the unit up
against the wall and slide
the Brackets against the
wall. Fit the 2nd Screw
from the kits into the
underside of the Top
panel.
Mark the slot at the back
of the Brackets for drilling
into the wall.
Wall fixings are not
supplied as they will need
to suit the wall type.
L
L
L
L
L
This unit must be fixed to a wall using the
2 Overbalance Protector Kits provided
a:
b:
Q
L
L
Top
Q
Q
Q
Take care when drilling
the wall that you do not
drill into any pipes, wires
etc. If in doubt, consult
an expert.