ABACOM Technologies TX-FM 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} ABACOM Technologies TX-FM에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABACOM Technologies TX-FM 4 페이지.

A) Helical, fig. 4a: Wire coil, connected directly the antenna pin of the particular module and open circuit

at the other end. This antenna is very efficient given its small size (20mm x 4mm dia). The helical is a high

Q antenna, trimming the wire length or expanding the coil may be performed for optimum results. The

helical de-tunes badly with proximity to other conductive objects.

B) Loop, fig. 4b: A loop of PCB track tuned by a fixed or variable capacitor to ground at the 'hot' end and

fed from the antenna pin at a point 15 to 25% from the ground end. Loops have high immunity to proximity

de-tuning.

C) Whip, fig. 4c: This is a wire, rod, PCB track or combination connected directly the antenna pin of the

RF module. Optimum total length is 17cm (1/4 wave at 418 MHz) or 16.5cm (1/4 wave at 433.92MHz).

Keep the open circuit (hot) end well away from metal components to prevent serious de-tuning. Whips are

ground plane sensitive and will benefit from internal 1/4 wave earthen radial if the product is small and

plastic cased.

Antenna selection chart:

Ultimate performance

Ease of design setup

Size

Immunity to proximity effects

The antenna choice and position directly controls the system range. Keep it clear (particularly the 'hot' end)

of other metal in the system particularly large ones like transformers, batteries and PCB tracks/ground

plane. The space around the antenna is as important as the antenna itself.,. The best position by far, is

sticking out the top of the product. This is often not desirable for practical/ergonomic reasons and a

compromise may be necessary.

• •

32 Blair Athol Crescent • Etobicoke • ON • M9A 1X5 • Canada • Tel +416-236-3858 • Fax +416-236-8866 •

Helical

***

Fig 4.

ABACOM Technologies

Loop

Whip

***