Aqua One AirO2Pod 240 매뉴얼 - 페이지 2

{카테고리_이름} Aqua One AirO2Pod 240에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua One AirO2Pod 240 5 페이지.
Aqua One AirO2Pod 240에 대해서도 마찬가지입니다: 지침 (6 페이지)

페이지 인쇄

Important Safeguards

To guard against injury, basic safety precautions should

be observed, including the following:

1. Read and follow all safety instructions and important

notices in these instructions as well as on the product itself.

2. This appliance can be used by children aged from 8 years

and above and persons with reduced physical, sensory or

mental capabilities or lack of experience and knowledge if

they have been given supervision or instruction concerning

use of the appliance in a safe way and understand the

hazards involved.

Children shall not play with the applicance.

Cleaning and user maintenance shall not be made by children

without supervision.

3. To avoid possible electric shocks, special care should

be taken since water is employed in the use of aquarium

equipment. For each of the following situations do not attempt

repairs yourself. Return the appliance to an authorised service

facility for service or discard the appliance.

a. If the appliance or any electrical component of the appliance

(non-immersible equipment only) falls into the water or gets

wet, do not reach for it. Unplug it and then retrieve it.

b. If the appliance shows any sign of abnormal water leakage,

immediately unplug it from the power source

c. Carefully examine the appliance after installation. It should

not be plugged in if there is water on parts which are not

intended to be wet.

4. If you wish to use the pump above the water level of the

aquarium, it should be fixed by screw (d. Mounting Point) to a

solid surface (except Stellar 50).

5. Always unplug the appliance from the electrical outlet

when not in use, before putting on or taking off parts, before

any type of maintenance or cleaning.

6. Never yank the cable to pull it from the socket. Pull the plug

carefully to disconnect.

7. Do not use the appliance for reasons other than the intended

use. The use of attachments that are not recommended or

sold by the manufacturer may cause the product to be unsafe.

This is not recommended.

8. Do not install or store the appliance where it will be exposed

to weather or temperatures below freezing.

9. Make sure any component mounted on a tank is securely

installed before operating it.

10. Ensure input voltage is the same voltage as your local

power supply.

11. If an extension cable is used it should have the proper

rating. Care should be taken to arrange the cord so that it will

not be tripped or pulled.

12. A G.F.C.I (Ground fault circuit interrupter) & surge protector

is recommended for all electrical appliances.

13. Ensure your hands are dry, plug the pump in and turn on.

Remember to arrange a drip loop (see graphic).

14. If you are in any doubt about the electrical installation or

safety of this product you must consult a qualified electrician.

15. The supply cord must not be repaired or replaced. If it is

damaged, replace the entire pump unit.

16. Turn the pump off and remove the air filter. Clean or replace

as necessary on a regular basis.

Before First Use / Preparation

Read and follow all the instructions, even if you feel you are

familiar with the product and find a place to keep the instructions

handy for future reference. Your attention is drawn particularly to

the sections concerning "IMPORTANT SAFEGUARDS" and the

"GUARANTEE CONDITIONS". Please ensure you retain your

original purchase receipt in the event that guarantee service is

required.

Carefully unpack the product making sure you keep all the

packing material until all the parts of the product have been found

and the product has been assembled.

This product was packaged in excellent condition in the factory.

Should you find that the product is damaged, has been dropped,

or malfunctions in any way, contact the retailer where the product

was purchased, for inspection. Please insure you retain your

original purchase receipt in the event that warranty service is

required.

All products are supplied with fitted plugs. This plug should not

be tampered with in any way or removed. Removal or tampering

with the plug invalidates our guarantee offered with this product.

For UK a 3 pin adaptor is supplied with the product and this must

be used.

Know your pump

a. Air outlet

b. Rubber feet

c. Air filter

d. Power cord

e. Screws

Always ensure the power cord is not plugged in when

maintenance is being carried out on the pump.

Air In

Hints & Tips for Best Results

Air Stone:

•

Replace the air stone every 6 months or when it

shows signs of deterioration.

•

If being used in salt water a plastic or ceramic air

stone is recommended.

Step by step guide

1. Decide where you are going to position the air

pump. Remember the pump must remain accessible for

maintenance.

2. Where possible place the pump above the aquarium. Avoid

placing the pump on a carpeted surface.

3. If this is not possible then ensure that a check valve is fitted

to the airline, failure to do so will damage your air pump & void

your Guarantee. Ensure the check valve is inserted correctly.

They only flow one way. Refer to diagram.

4. It is best to position the check valve as close to the aquarium

as possible, as shown in the picture below.

5. Attach one end of the air line into your ornament or air

stone.

6. Attach the other into the outlet of your pump.

7. Position your pump. Ensure it is not going to vibrate off what

ever surface you place it on.

8. Ensure your hand is dry, plug the pump in and turn on.

Remember to arrange a drip loop.