AVOURY ONE 사용자 설명서 - 페이지 14

{카테고리_이름} AVOURY ONE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVOURY ONE 20 페이지.
AVOURY ONE에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 빠른 매뉴얼 (10 페이지), 빠른 매뉴얼 (3 페이지)

페이지 인쇄

C L E A N I N G A N D D E S C A L I N G

Cleaning and

Descaling

The cleaning and descaling program-

me must be completed once started.

Stopping this process prior to comple-

tion, e.g. as a result of an interruption

in the power supply, causes the pro-

gramme to restart or may lead to error

notifications in exceptional cases (all

four info LEDs

flashing).

Before putting in a capsule for cleaning

or descaling, the care mode must be

activated. If care mode is deactivated

the capsule will be ejected.

Activate care mode

Switch on the tea machine.

2. Activate the care mode by pressing the filling

capacity –

and brewing time button +

simultaneously for approx. 3 seconds. When

the first LED at –

at +

show a continuous light the care

mode is activated.

3. To deactivate the care mode, if necessary,

press and hold the filling capacity –

brewing time button +

ly for approx. 3 seconds.

Important: Care mode is deactivated when:

the Avoury One tea machine is turned off /

•

turns off automatically

the cleaning/ descaling programme is

•

finished.

are

and the last LED

and

again simultaneous-

Cleaning

When the LED "Carry out cleaning"

continuous light, the appliance should be clea-

ned using a cleaning capsule. The programme

takes approximately 25 minutes.

Switch on the tea machine and wait until the

Start-Button

shows a continuous light.

2. Fill up the water tank

fresh tap water and then insert the water

tank again.

3. Activate the care mode.

4. Open the capsule compartment

the lid foil from the cleaning capsule and

insert a cleaning capsule. Then close the

capsule compartment

5. The LED "Carry out cleaning"

flash red and the Start-Button

continuous light.

The LED "Carry out cleaning"

red throughout the whole cleaning

programme and goes off when the

programme is finished.

6. To start the cleaning programme, press the

Start-Button

7. When the LED "Empty capsule container"

shows a continuous red light, remove the

drip drawer

and empty the drip tray and

the capsule container (Removal must also be

performed if the capsule drawer is empty. If

the LED remains lit after removal, wipe the

inner housing dry so that the sensors are not

prevented by the moisture).

shows a

completely with

, remove

starts to

shows a

flashes

PAGE 35