DFI DT122-GH 설치 매뉴얼 - 페이지 2

{카테고리_이름} DFI DT122-GH에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DFI DT122-GH 4 페이지.

DFI DT122-GH 설치 매뉴얼
Removing the Chassis Cover
1.
Make sure the system and all other peripheral devices connected to it have been
powered-off.
2.
Disconnect all power cords and cables.
3.
The 4 mounting screws on the left and right sides of the system are used to
secure the cover to the chassis. Remove these screws and put them in a safe
place for later use.
Installing a SODIMM
The system can accommodate
two DDR4 memory modules (dual
channel).
SO_DIMM1
(closer to the center of
the board)
SO_DIMM2
Installing an M.2 Card
The onboard M.2 Type 2280 connector
(M Key) supports PCIe NVMe modules
up to PCIe Gen 3.0 x4 bandwidth.
Installing a 2.5" or 3.5" SATA Drive
Installing a 2.5" SATA Drive
The system can accommodate
one 3.5" HDD or two HDDs.
1.
To install a 2.5" HDD, use
the 2.5" HDD bracket as
shown on the right.
Mounting Screws
Mounting Screw
HDD Bracket
2
SATA Drive